hand launch airplane MG1
3d printing volume required (220 x 220 x 250 mm)
| Wingspan: | 1307mm (51.4 inches) |
| Lenght: | 755mm (29.7 inches) |
| Height: | 155mm (6.1 inches) |
| Wing loading: | 56.35g/dm2 |
| Center of gravity: | 35 mm / 1.3 in = from leading edge |
| Airfoil: | GOE 602 AIRFOIL |
| Print weight (LW PLA/pet-g): | 470g |
| Print weight (100% LW PLA): | 375g |
| Take off weight (LW PLA/pet-g): | 840g |
| Take off weight (100% LW PLA): | 745g |
| Motor: | BL Outrunner 2826/12 1450 KV |
| ESC: | EP Aer33-Aer-Series 33A Flug ESC |
| Propeller: | APC PROPELLERS Slowfly-Propeller 8×3.8 “ |
| Battery: | 3S 11.1V 1250mAh 30C/60C |
| for 4-channel control: | Motor, rudder, elevator, ailerons (Delta setting) |
slicer
print profile
print parts
assembling manual
accessories
Center of gravity
maiden flight